Parts You Forget to Clean: Extractor, Ejector
Shooters clean bores religiously and ignore the parts that actually cause stoppages. If your pistol or rifle has feeding or extraction issues, these three are where to look first.
1. Extractor claw
The extractor grips the case rim and pulls it out. Carbon packs under the claw, weakening grip - the classic failure to extract.
- Detail with a pointed swab plus a nylon brush
- Check the claw for chips - a damaged extractor will not be fixed by cleaning
- Leave it dry or barely filmed; heavy oil here collects carbon fast
2. Ejector
A fixed or spring-loaded post that kicks the case out. Carbon and brass shavings around its base cause stovepipes and erratic ejection. Wipe it, check it is not bent, done.
3. Magazines (the most neglected of all)
A dirty magazine causes more malfunctions than a dirty bore. Disassemble if your design allows:
- Wipe the follower and inside body - range grit plus magazine lube turns to paste
- Check spring tension and replace tired springs
- Keep magazines dry - oil inside a magazine attracts debris
- Do not store loaded magazines for years without rotating (spring fatigue is debated, but grime is not)
The five-minute addition to your routine
After the bore: swab extractor, wipe ejector, wipe magazine follower. Three minutes. It converts "clean gun, unreliable gun" into "clean gun, reliable gun."
Frequently asked questions
Should the extractor be lubricated?
Basically no - a dry or micro-film extractor stays cleaner. Carbon plus oil is how it gums up.
How often should magazines be disassembled and cleaned?
Every few range trips for carry/duty magazines; seasonally for range-only use.
Does this apply to rifles too?
Absolutely - AR bolt extractors and magazine followers are the same story.
Related: 7 Cleaning Mistakes to Avoid | .223/5.56 Cleaning Routine | Cleaning a Revolver Cylinder | Cleaning Pistol Magazines
