How to Clean Pistol Magazines & Followers
Ask any armorer what causes the majority of semi-auto malfunctions and magazines will be near the top of the list - above the gun itself. They live in pockets, get dropped, collect lint, and are almost never cleaned.
How often
For a carry or competition magazine, clean it every few range trips or whenever it has been dropped in dirt. For range-only magazines, a few times a year is usually enough. The exception: if a magazine has been dropped in sand, mud or snow, clean it before you rely on it again.
What you need
Very little: a dry microfiber cloth, some lint free wipes, a light solvent for the exterior, and a non-chlorinated aerosol or just dry patches for the interior. A nylon brush helps on stubborn carbon at the feed lips.
The cleaning sequence
Step 1 - Unload and confirm empty
Visually and physically confirm the magazine is empty before anything else. Then remove the baseplate - most designs use a catch or a sliding plate, and some require depressing a retaining pin.
Step 2 - Strip it carefully
Springs are under tension. Release the baseplate in a controlled way with the magazine pointed into a container, or the spring and follower can launch across the room. Lay the parts out in order so reassembly is obvious.
Step 3 - Wipe the interior dry
Run a dry wipe or patch through the magazine body. You are removing lint, dust and powder residue - not grease, because there should not be any.
Step 4 - Clean the follower and spring
Wipe the follower clean, including the surfaces that ride inside the body. The spring needs little more than a wipe - do not soak it.
Step 5 - Clean the feed lips
The feed lips are where carbon and brass dust accumulate and where dimensional damage matters most. Wipe them; a nylon brush helps. Do not file, bend or "adjust" feed lips unless you know exactly what you are correcting.
Step 6 - Reassemble dry
Put it back together dry. This is the step most people get wrong.
Why no oil inside a magazine
Oil inside a magazine body attracts and holds dust, powder residue and lint. Within a few range trips it turns into a grinding paste that slows the follower - the exact opposite of what you want. Magazine interiors should be clean and dry. If a spring sounds gritty, it is dirty, not dry.
The exterior can get a very light wipe of protectant; a silicone cloth pass on the outside metal is enough. Keep it off the follower path.
Springs are consumable
Magazine springs fatigue. If a magazine that used to run reliably starts producing failures to feed, or the follower feels weak, replace the spring rather than stretching it - stretching a spring is a temporary fix at best.
Marking your magazines with a number or colour lets you track which one misbehaves, which turns a vague reliability problem into a specific fix.
Frequently asked questions
Should I lubricate magazine springs?
No. Keep the interior dry. Oil collects debris and slows the follower.
How do I know a magazine is worn out?
Spread or damaged feed lips, a cracked body, a weak follower, or persistent failures to feed after a clean spring. Bodies and springs are cheap compared to a malfunction.
Can I leave magazines loaded indefinitely?
Compression does not meaningfully fatigue a quality spring - repeated cycling does. Loaded storage is fine for practical purposes.
Related: Parts Everyone Forgets to Clean | 9mm Pistol Cleaning Guide
