How to Clean a Revolver: Cylinder & Forcing Cone
Revolver cleaning is simpler mechanically than a semi-auto, but it has fouling traps that semi-auto owners never think about. Three areas decide whether your revolver stays smooth: the cylinder chambers, the forcing cone, and under the extractor star.
Area 1: Cylinder chambers
Each of the six (or seven, or eight) chambers builds carbon rings, especially with .38 Special fired in a .357 chamber - the shorter case leaves a ring that can stop .357 rounds from seating fully.
- Brush each chamber with a caliber-correct bronze brush and solvent
- Patch each chamber dry
- For stubborn rings, a chamber brush on a drill at low speed with solvent works - carefully
Area 2: The forcing cone and top strap
The forcing cone is where the bullet transitions from cylinder to barrel. Lead and carbon build up here and can cause cylinder binding. Above it, the top strap collects a characteristic grey lead smear from the cylinder gap - normal, but it should be removed.
- Nylon brush plus CLP on the forcing cone
- Wipe the top strap; a lead-removing cloth helps with the smear
- Check the barrel-cylinder gap visually while you are there
Area 3: Under the extractor star
The most-skipped spot on any revolver. Fouling under the star causes hard extraction and erratic cylinder rotation.
- Swab under the star with a pointed cotton swab
- Keep it dry or barely filmed - oil here collects powder debris
Lubrication: less than you think
A drop of CLP on the crane (yoke) where the cylinder rotates, a tiny amount on the hammer/sear interface, and nothing in the chambers. Oil in chambers plus firing pressure is how cases stick.
Frequently asked questions
Do I need to remove the cylinder every time?
No for routine cleaning - but do it periodically to clean the crane and under the extractor properly.
Why does my cylinder bind after shooting?
Usually fouling under the extractor star or on the forcing cone, not the action itself.
Can I use the same patches as my pistol?
Yes if the caliber matches - .357/.38/.9mm share patch sizes.
Related: Cleaning a 9mm Pistol
